Thread Wall Tutorial

Thread Wall Tutorial

Is your thread hidden in every crack and crevice and stuck in drawers? I have alot of thread that's true, but keeping it organized was something I desperately needed to do once the thread seemed to multiply. So I looked and looked and all I could find in the beginning was those cheap little thread stands you get at the craft store,  that worked for a little while but it seemed my thread was multiplying in numbers so something else was needed, then I happened to find this site on the Internet (can't remember the name of it) that a clever girl named Mandy had done using peg board and dowels and Voila!! Here it is!!! Handy and organized and no more hunting for that color you know you have somewhere!!

Supplies needed:

1/4 in pre-cut Peg Board

you can find peg board pre-cut at your local home center

1/4 dowels

picture frame moulding for trim - has a lip on it to overlap the peg board

glue- I used Elmer's all purpose glue

small hand saw

sandpaper

Spray Paint- in your color choice

Map out how you want your thread to go, I used some spare empty spools to do this, to get the proper spacing and to decide where to put the serger thread and larger spools. I had originally measured for rulers down the center but the thread is still growing so I left the center undone for now in case I needed some growing room.

I measured the dowels to be cut in 3 inch increments, leaving enough space for the glue end and sanded on one end. I sanded one end of the dowel so that the rough end would be the glue end into the peg board and the smooth end would be the end where the spool was loaded for a splinter free effect!

Once you have mapped out and glued all the dowels in place take your new thread wall out side careful not to hit the dowels and damage all that hard work! Lay it down on some newspaper and get your spray paint can ready, I used white spray paint because the peg board was already white on one side and I wanted a uniform look, now spray paint that thread wall and be careful not to spray to close as you'll get runs in the paint, I did this on a nice hot day and the paint dried in a couple of hours.

Once dry take your thread wall and hang it (I used dry wall screws and then painted the tops white) in its designated spot on the wall (get someone to help center it and make sure its level), get your trim and measure, cut ( I cut the trim on a 45 degree angle for a true picture frame effect), paint ( I used some paint left over from a previous project and a simple dollar store paint brush) and hang it overlapping the peg board.

Finished and organized! Notice the thread is color coded so that you can find the right color in no time!!